Kia Forte: Hub nut tightening sequence

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / maincat / Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

2.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.0118)	Below 1.4(0.0551)
Lateral mm(in.)	Below 0.3(0.0118)	Below 0.9(0.0354)

3.	If measured value exceeds the standard value, replace the wheel.

maincat

...

Tire Pressure Monitoring System

...

See also:

AGM Battery Removal
1. Disconnect the battery terminals (A). (1) Tightening torque (+) terminal : 7. ...

Line Pressure Control Solenoid Valve Circuit Diagram
...

Room Lamp Removal
Room Lamp 1. Disconnect the negative(-) battery terminal. 2. Carefully remove the lamp lens (A) from the room lamp with a flat-tip scre ...

Categories

Copyright © www.kifomanual.com 2014-2026