Kia Forte: Ignition Switch Assembly

Start/Stop Button Installation

1. Install the start/stop button. 2. Connect the start/stop button connector. 3. Install the cluster fascia pan ...

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Low Panal") ...

See also:

Overhead Console Lamp Inspection
1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function Connector [CNG-AA] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output Ignition Co ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Circuit Diagram
...