Kia Forte: Start/Stop Button Installation

Start/Stop Button Removal

1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center garnish [LH] (A). ...

Ignition Switch Assembly

...

See also:

ETC (Electronic Throttle Control) System Schematic Diagram
...

Adjustment
Stop lamp switch clearance adjustment If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below. 1. Disconnect the s ...

Inspection
If any of the following conditions occur, WCS reset and accuracy check should be performed. • The WCS ECU or any of the sensors is replaced. • ...