1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the center garnish [LH]
(A).
|
3. |
Using a screwdriver or remover, remove the cluster fascia panel
(A).
|
4. |
Remove the start/stop button (A) after loosening the screws from
the cluster fascia panel.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive Clutch(OD/C) Control Solenoid Valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the Overdrive Clutch(OD/C)
...
Oil Pressure Switch Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1 ...
Specifications
AVN Head Unit
Item
Specification
Power supply
DC 14.4V negative ground
Load Impedance
4ohm × 4
Tuning type
PLL SYNTH ...