Kia Optima Manuals

Kia Forte: Injector Removal - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Injector Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Injector Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
  
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Disconnect the injector connector (A).
4.
Disconnect the fuel feed tube quick-connector (B).
5.
Remove the installation bolt (C), and then remove the delivery pipe & injector assembly from the engine.
6.
Remove the fixing clip (A), and then separate the injector from the delivery pipe.
Injector Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Injector Installation
   • Install the component with the specified torques. • ...

See also:

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

Special Service Tools
Tool Name / Number Illustration Description Band installer 09495-3K000 Installation of ear type boot band Puller 09495-33000 ...

Rear Center Seat Belt Retractor Component Location
(4Door) 1. Rear center seat belt retractor (5Door) 1. Rear center seat belt retractor ...

Categories

Copyright www.kifomanual.com 2014-2026