Kia Forte: Injector Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply the engine oil to the injector O-ring.
|
|
| •
|
Inspect the injector O-ring when installing.
|
|
|
1. |
Install in the reverse order of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line (Refer to the ...
Purge Control Solenoid Valve (PCSV) is installed on the intake manifold
and controls the evaporative purge between the canister and the intake manifold.
It is a normally closed solenoid valve ...
See also:
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by the signal from the control unit. Pressing the intake selection switch
will shift between recirculation and ...
Rear Oil Seal Removal
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Remove the manual transaxle.
(Refer to Manual ...
Climate control system
є
1. Fan speed control knob
2. Mode selection knob
3. Temperature control knob
4. Air conditioning button
5. Air intake control button
6. Rear window defroster button
Heating and air conditi ...
Injector Removal
Purge Control Solenoid Valve (PCSV) Description