Kia Forte: Inspection - Electro Chromic Inside Rear View Mirror - Body Electrical System - Kia Forte TD 2014-2019 Service ManualKia Forte: Inspection

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Body Electrical System / Electro Chromic Inside Rear View Mirror / Inspection

Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front sensor to stop functioning.
3.
Shine a light at the rear sensor.
4.
The ECM should be darkened as soon as the rear sensor detects the light.
  
If this test is performed in daytime, the ECM may be darkened as soon as the front sensor is covered.
5.
When the reverse gear is engaged, the ECM should not be darkened.
6.
When heading lights to both the front and rear sensors, the ECM should not be darkened.
Automatic-dimming Function
To protect your vision during nighttime driving, your mirror will automatically dim upon detecting glare from the vehicles traveling behind you. The auto-dimming function can be controlled by ...

Removal
1. Remove the mirror wiring cover (A). 2. Disconnect the mirror connector (B). 3. Loosen the mirror mou ...

See also:

Ignition Coil Specification
Item Specification Primary Coil Resistance (Ω) 0.75 ± 15% [20°C (68°F)] Secondary Coil Resistance (kΩ) 5.9 ± 15% [20°C ( ...

Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

Canister Close Valve (CCV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

Copyright © www.kifomanual.com 2014-2019