Kia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Cover And Disc / Inspection

1.	Inspect diaphragm spring wear which is in contact with a clutch release bearing.

2.	Check the clutch cover and disc surface for wear or cracks.

3.	Check the clutch disc facing for slipping or oil marks.

4.

Measure the depth from a clutch facing surface to a rivet. If the measured value is less than the specification below, replace it.

Clutch disc rivet depth (A) :

0.3 mm (0.0118 in.)

Removal

1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the clutch cover bolts. ...

Installation

Clutch cover and disc should be replaced as a set. 1. Apply grease on a disc spline ...

See also:

CVVT & Camshaft Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Back up lamp, Rear fog lamp
1. Take the lamp assembly out. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb by ...

Rear Shock Absorber Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Categories

Copyright © www.kifomanual.com 2014-2026