Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the clutch switch.

(1)

Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range:

0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box (Refer to Body Electri ...

Ignition Lock Switch

...

See also:

Oil Cooler Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. ...

Installation
1. Install in the reverse order of removal. 2. Rotate the caliper piston and push the direction of the arrow. 3. ...

Record your key number
The key code number is stamped on the key code tag attached to the key set. Should you lose your keys, this number will enable an authorized Kia dealer to duplicate the keys easily. Remove the k ...

Categories

Copyright © www.kifomanual.com 2014-2026