Kia Forte: Knock Sensor (KS) Installation

Knock Sensor (KS) Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). ...

Heated Oxygen Sensor (HO2S) Description

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Catalytic Converter. It varies in accordance with the air/fuel ratio. Th ...

See also:

Compressor Installation
1. Make sure the compressor mounting bolt with the correct length is screwed in. Tighten the mounting bolts (A) with the specified tightening order. ...

Transaxle Oil Temperature Sensor Installation
1. Install in the reverse order of removal.    After replacement or reinstal ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...