Kia Forte: Knock Sensor (KS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the knock sensor connector (A).
|
| 3. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
| 4. |
Remove the installation bolt (A), and then remove the sensor from
the cylinder block.
|
Knock Sensor (KS) Circuit Diagram
(M/T)
(A/T)
...
Knock Sensor (KS) Installation
•
Install the component with the specified torques.
•
...
See also:
Timing Chain Installation
1.
Check that the TDC marks on the intake and exhaust CVVT sprockets
are slightly turned (about 2 to 3 teeth) from the TDC position after
the timing chain has been rem ...
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Rear Bumper Beam Assembly Component Location
(4Door, 2Door)
1. Rear bumper beam assembly
(5Door)
1. Rear bumper beam assembly
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026