Kia Forte: Outside Rear View Mirror Replacement - Mirror - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Outside Rear View Mirror Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Mirror / Outside Rear View Mirror Replacement

(4Door, 5Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).

2.
Disconnect the outside rear view mirror connector (B).
3.
After loosening the mounting bolts, then remove the outside rear view mirror (A).

Tightening torque :
6.9~10.8 N.m(0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Install in the reverse order of removal.
  
Make sure the connector is connected properly.
Replace any damaged clips.
(2Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).

2.
Loosen the outside rear view mirror mounting screw (A).

3.
After loosening the mounting bolts, then remove the outside rear view mirror (A).
4.
Disconnect the outside rear view mirror connector (B).

Tightening torque :
6.9~10.8 N.m(0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

5.
Install in the reverse order of removal.
  
Make sure the connector is connected properly.
Replace any damaged clips.
Outside Rear View Mirror Component Location
(4Door, 5Door) 1. Outside rear view mirror (2Door) 1. Outside rear view mirror ...

Inside Rear View Mirror  Component Location
1. Inside rear view mirror ...

See also:

Relay Box (Passenger Compartment) Description
Smart Junction Box(SJB) 1. General function : Interior Junction Box + some functions of BCM It controls loads with CAN communication and IPS. 2. ...

Front Impact Sensor (FIS)
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

Components
...

Copyright www.kifomanual.com 2014-2026