Kia Optima Manuals

Kia Forte: Power Door Lock Actuators Inspection - Power Door Locks - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Power Door Lock Actuators Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators Inspection

Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
Disconnect the connector from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Rear Door Lock Module Inspection
1.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
2.
Remove the rear door module.
(Refer to Body - "Rear Door Module")
3.
Disconnect the connector from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Trunk Lid / Tailgate Release Module Inspection
[2/4 Door]
1.
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
2.
Disconnect the connector from the actuator.
[2 Door]

[4 Door]
3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
[5 Door]
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Disconnect the connector from the actuator.
3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Component Location
1. Driver power window switch 2. Door lock switch (Driver) 3. Passenger power window switch 4. Door lock switch (Passenger) 5. BCM (Body Control Module) 6. Front door loc ...

Power Door Lock Relay Inspection
Diagnosis With GDS 1. It will be able to diagnose defects of power door lock with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring ...

See also:

Compressor Components
1. Center Bolt 2. Hub Bolt 3. Disc & Hub Assembly 4. Snap Ring 5. Pulley 6. Compressor Assembly 7. Electric Control Valve (ECV) ...

Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Shift Lever Removal
1. Remove the floor console assembly. (Refer to Body - "Floor Console") 2. Remove the air duct. 3. ...

Categories

Copyright www.kifomanual.com 2014-2026