Kia Forte: Inspection
Component Inspection
| 1. |
Remove the ignition lock switch.
|
| 2. |
Push the ignition lock switch in the direction of the arrow to
make sure that continuity between terminals. (refer to the table below)
|
Specifications
Item
Specifications
Working voltage
DC 12V
Operating force
9.8 ± 2.9N
(1.0 ± 0.3kg, 7.2 ± 0.7lb)
Working temperature
...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the smart junction box.
(Refer to Body Electri ...
See also:
Manifold Absolute Pressure Sensor (MAPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Conditio ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
Copyright © www.kifomanual.com 2014-2019