Kia Forte: Power Door Lock Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch Inspection
Driver Door Lock Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Passenger Door Lock Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check the continuity between the terminals in each switch position
according the the table.
|
Power Door Lock Relay Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of power door lock with GDS
quickly. GDS can operates actuator forcefully, input/output value monitoring
...
Power Door Lock Switch Removal
Driver Door Lock Switch
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front ...
See also:
Driver assistance systems
Warning
Driver assistance systems are
developed to support the driver
and not to replace the driver's
attention.
The driver accepts full
responsibility when driving the
vehicle.
When using driver ...
Oil Pump Unit (OPU) Installation
1.
Install in the reverse of removal.
...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Copyright © www.kifomanual.com 2014-2025