Kia Forte: Rear Combination Lamp Removal - Lighting System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Combination Lamp Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Removal

Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp cover (A).

3.
Remove the mounting nuts (4EA).
4.
Remove the rear combination lamp (B) after disconnecting the connector (A).

5.
Replace turn signal lamp (A) and stop/tail lamp (B) by turning the sockets counterclockwise.

Rear Combination Lamp (Inside)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Refer to Body - "Trunk Trim")
3.
Remove the rear lamp assembly after removing the nuts (3EA) and connector (A).

4.
Replace the backup lamp (A) and stop lamp (B) by turning the sockets counterclockwise.
[General Type]

[LED Type]

High Mounted Stop Lamp Installation
[2 Door] 1. Install the high mounted stop lamp assembly. 2. Install the roof trim assembly. [4 Door] 1. ...

Rear Combination Lamp Installation
1. Install the rear combination lamp (Inside) assembly. 2. Install the rear combination lamp (outside) assembly. ...

See also:

Rear Torsion Beam Axle Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the rear axle carrier for cracks. ...

Front Washer Motor Removal
   - When servicing the washer pump, be careful not to damage the washer pump seal. ...

Setup
Display Settings Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up] Changes / selection mode During On stat ...

Copyright © www.kifomanual.com 2014-2026