1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the rear wheel and tire (A) from rear hub .
|
3. |
Remove the brake caliper mounting bolts, and then place the brake
caliper assembly (A) with wire.
|
4. |
Loosen the mounting screws and then brake disc (A).
|
5. |
Loosen the bolts and then remove the hub bearing (A).
|
6. |
Install in the reverse order of removal.
|
7. |
Check the rear alignment.
(Refer to Suspension System - "Rear Alignment")
|
IMS Power Seat Control Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Removal
1.
Disconnect the battery negative cable and wait for at least thirty
seconds before beginning work.
2.
Remove the glove box housing.
...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
...