Kia Forte: Rear Seat Cushion Cover Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the rear seat heater control unit connector (A).

3.	After removing the hog-ring clips (A) on the rear of seat cushion and remove the rear seat cushion cover (B). [Rear side] [Front side]

4.

Install in the reverse order of removal.

•	To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Rear Seat Cushion Cover Component Location

1. Rear seat cushion cover ...

Rear Back Armrest Component Location

1. Rear back armrest ...

See also:

Thermostat Components
1. Water inlet fitting 2. Thermostat 3. Bypass hose 4. Heater pipe & hose assembly ...

Components
1. Receiver 2. TPMS Sensor 3. TPMS Sensor 4. TPMS Sensor 5. TPMS Sensor ...

Hands Free Mic Inspection
1. Disconnect the negative(-) battery terminal. 2. Remove the handsfree mic (A) after disconnect the connector from roof trim. ...

Categories

Copyright � www.kifomanual.com 2014-2026