Kia Forte: Rear Seat Latch Replacement - Rear Seat - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Seat Latch Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Latch Replacement

(4Door, 2Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
After loosening the mounting clips and screws, then remove the rear partition trim (A).

4.
Press the lock pin (A) located in the trunk and remove the rear seat back folding cable handle (B) by pushing it back.

5.
After loosening the mounting bolts, then remove the rear seat latch assembly (A).

Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

6.
Install in the reverse order of removal.
  
Replace any damaged clips.
(5Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat back cover [LH]or [RH].
(Refer to Rear Seat - "Rear Seat Back Cover")
2.
After loosening the mounting bolts and screws, then remove the rear seat latch (A).

Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

3.
Remove the rear seat latch rod (A) to direction of the arrow.

4.
Install in the reverse order of removal.
Rear Seat Latch  Component Location
(4Door, 2Door) 1. Rear seat latch assembly (5Door) 1. Rear seat latch ...

Front Seat Belt
...

See also:

Specification
Item Type Watt (W) Head lamp Low STD H11 55 HID D8S 25 High H1 55 Turn ...

Removal
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Cooling Fan Inspection
Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...

Copyright © www.kifomanual.com 2014-2024