Kia Forte: Removal - Yaw-rate and Lateral G Sensor - ESC(Electronic Stability Control) System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / ESC(Electronic Stability Control) System / Yaw-rate and Lateral G Sensor / Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Pull the passenger seat towards the front till the end.
3.
Disconnect the yaw rate & lateral G sensor connector (A).

4.
Remove the mounting bolts (B).

Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 Ib-ft)

5.
Install in the reverse order of removal.
  
In a case of replacing the Yaw rate sensor, operate "Longitudinal G Sensor Calibration" by GDS.
Yaw-rate and Lateral G Sensor
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor. If ya ...

G-Sensor Calibration
1. Ignition "OFF", connect GDS. 2. Ignition "ON" & Engine "OFF" select vehicle name and ESC system. ...

See also:

Components
...

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

Copyright www.kifomanual.com 2014-2026