Kia Optima Manuals

Kia Forte: Removal - Clutch Master Cylinder - Clutch System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Master Cylinder / Removal

1.
Separate the push rod (C) after remove the pin (A) and washer (B).
2.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
3.
Remove the ECM.
(Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
4.
Disconnect the clutch regulator (B) and reservoir hose (A) from the clutch master cylinder.
  
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

5.
Remove the master cylinder (A) by rotating in a clockwise direction.
Components
1. Reverse hose 2. Master cylinder 3. Ignition lock switch 4. Clutch switch 5. Clutch arm assembly 6. Pedal pad ...

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring ...

See also:

Special Service Tools
Tool Name / Number Illustration Description Alternator pulley remover wrench 09373-27000 Removal and installation of alternator pulley ...

Rear Shock Absorber Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Operation
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way val ...

Categories

Copyright � www.kifomanual.com 2014-2026