Kia Forte: Removal - Passenger Airbag (PAB) Module - Airbag Module - Restraint - Kia Forte TD 2014-2019 Service ManualKia Forte: Removal

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module / Removal

Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
Remove the glove box housing.
(Refer to Body - "Glove box housing")
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolts (B).

Remove the crash pad.
(Refer to Body - "Main crash pad assembly")
Replace the crash pad which is damaged while PAB is deployed.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

See also:

Antenna Coil Installation
1. Install the antenna coil. 2. Connect the antenna coil connector. 3. Install the crash pad lower panel. ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Head Lamp Leveling Actuator Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No. Procedure 1 Locate vehicle to flat ...

Copyright © 2014-2019