Kia Forte: Installation
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least thirty seconds before beginning work.
|
| 3. |
Place a passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
| 4. |
Install the crash pad.
(Refer to Body - "Main crash pad assembly")
|
| 5. |
Tighten the passenger airbag mounting bolts.
|
| 6. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
| 7. |
Reinstall the glove box housing.
(Refer to Body - "Glove box housing")
|
| 8. |
Reconnect the battery negative cable.
|
| 9. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Removal
Side Airbag (SAB) ModuleCrash Pad Upper Panel Component Location
1. Crash pad upper panel
...
Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...