Kia Forte: Room Lamp Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Room Lamp Removal
Room Lamp
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Carefully remove the lamp lens (A) from the room lamp with a flat-tip
screwdriver.
|
| 3. |
Replace the bulbs (A) and remove the screws if it is necessary.
|
| 4. |
Remove the room lamp assembly (A) after disconnecting the connector.
|
Vanity Lamp
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the vanity lamp (A) using a screwdriver or remover and
then disconnect the connector (B).
|
Room Lamp Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
Room Lamp Installation
Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
...
See also:
Cooling Fan Removal and Installation
Cooling fan assembly
1.
Disconnect the battery "-" terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to ...
Purge Control Solenoid Valve (PCSV) Description
Purge Control Solenoid Valve (PCSV) is installed on the intake manifold
and controls the evaporative purge between the canister and the intake manifold.
It is a normally closed solenoid valve ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel") ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026