Kia Forte: Room Lamp Installation - Lighting System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Room Lamp Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Room Lamp Installation

Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
Vanity Lamp
1.
Reconnect the vanity lamp connector.
2.
Install the vanity lamp.
Room Lamp Removal
Room Lamp 1. Disconnect the negative(-) battery terminal. 2. Carefully remove the lamp lens (A) from the room lamp with a flat-tip scre ...

Overhead Console Lamp Inspection
1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

See also:

Output Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Line Pressure Control Solenoid Valve Circuit Diagram
...

Front Oil Seal Replacement
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pulley") 2. Remove the front oil seal (A) ...

Copyright www.kifomanual.com 2014-2026