Kia Forte: Shift Lever Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2019 Service ManualKia Forte: Shift Lever Installation

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Installation

1.
Install in the reverse order of removal.
  
Install the cable after placing the shift lever and the transmission manual control lever in the N position.
Shift Lever Removal
1. Remove the floor console assembly. (Refer to Body - "Floor Console") 2. Remove the air duct. 3. ...

Shift Cable Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

See also:

Front Strut Assembly Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Battery saver function
The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the parking lights when the driver removes the ignition key and opens the driver- ...

Copyright © www.kifomanual.com 2014-2019