Kia Forte: Smart Key Unit Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Smart Key System / Smart Key Unit Installation
Smart Key Unit
| 1. |
Install the smart key unit and RF receiver.
|
| 2. |
Connect the connector and install the smart key unit.
|
| 3. |
Install the main crash pad assembly.
|
| 4. |
Install the negative (-) battery terminal and check the smart
key system.
|
Interior Antenna
| 1. |
Install the interior antenna.
|
| 2. |
Install the floor console assembly.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Trunk Antenna
| 1. |
Install the trunk antenna.
|
| 2. |
Install the rear transverse trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Exterior Bumper Antenna
| 1. |
Install the exterior bumper antenna.
|
| 2. |
Install the rear bumper cover.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Buzzer
| 1. |
Install the buzzer.
|
| 2. |
Install the front left wheel guard.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Door Outside Handle
| 1. |
Install the door outside handle.
|
| 2. |
Install the door trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Trunk Lid Open Switch
| 1. |
Install the trunk lid open switch.
|
| 2. |
Install the trunk trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Smart Key Unit Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main C ...
Smart Key Diagnostic Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
The following thr ...
See also:
Replacement
•
Be careful not to damage the fender and body.
...
Evaporator Core Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
...
Inspection
If any of the following conditions occur, WCS reset and accuracy check
should be performed.
•
The WCS ECU or any of the sensors is replaced.
•
...
Copyright © www.kifomanual.com 2014-2025