Kia Optima Manuals

Kia Forte: Sunroof Motor Inspection - Sun Roof - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Sunroof Motor Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Sun Roof / Sunroof Motor Inspection

1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the sunroof motor (A) connector.
4.
Ground the terminals as below table, and check that the sunroof unit operates.
  
-
When inspecting the sunroof motor operation, sunroof motor and roller blind motor always should be connected.

5.
Make these input tests at the connector. If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the sunroof motor must be faulty; replace it.
Terminal
 Test
condition
 Test: Desired result
3
 IG2 ON
 Check for voltage to ground:
There should be battery voltage.
1
 Under all
conditions
 Check for continuity to ground:
There should be continuity.
6
 Under all
conditions
 Check for voltage to ground:
There should be battery voltage.

Sunroof Switch Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly (A) after loosening 2 screws. ...

Resetting The Sunroof
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows : 1. ...

See also:

Circuit Diagram
...

Line Pressure Control Solenoid Valve Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Front Bumper Cover Replacement
   • Put on gloves to protect your hands. ...

Categories

Copyright www.kifomanual.com 2014-2026