Kia Optima Manuals

Kia Forte: Temperature Control Actuator Replacement - Heater - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: Temperature Control Actuator Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Temperature Control Actuator Replacement

[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel")
3.
Remove the driver's side shower duct by loosening the screw.
4.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
5.
Install in the reverse order of removal.
[Passenger's side]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body -"Glove Box Housing")
3.
Remove the passenger's side shower duct by loosening the screw.
4.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
5.
Install in the reverse order of removal.
Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

See also:

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross V ...

Installation
1. Install the BCM unit. 2. Install the center lower cover. 3. Install the floor console assembly. ...

Inspection
1. Inspect the check valve in the vacuum hose.    Do not remove the check va ...

Categories

Copyright www.kifomanual.com 2014-2026