Kia Forte: Transaxle Oil Temperature Sensor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to Transaxle Oil Temperature Sensor - "Specifications")
|
Transaxle Oil Temperature Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
See also:
Room Lamp Removal
Room Lamp
1.
Disconnect the negative(-) battery terminal.
2.
Carefully remove the lamp lens (A) from the room lamp with a flat-tip
scre ...
Cylinder Head Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Copyright © www.kifomanual.com 2014-2025