Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
(Refer to Underdrive Brake Control Solenoid Valve - "Specifications")
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Circuit Diagram
...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

MENU : My Music Mode
In My Music mode, press the key to set the Repeat, Random, Information, Delete, Delete All, and Delete Selection features. Repeat Press the key Set [  RPT] through the TUNE kn ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Components
1. Union bolt 2. Gasket 3. Tube joint 4. Clutch tube 5. Valve plate 6. Valve spring 7. Bleeder screw 8. Release cylinder 9. Return spring 10. Piston 11. Bo ...

Copyright www.kifomanual.com 2014-2026