Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive Clutch(OD/C) Control Solenoid Valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the Overdrive Clutch(OD/C)
...
See also:
Replacement
1.
Remove the cap (A) and remove the nuts, then remove the wiper
arm (B).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 ...
Seat Belt Switch Inspection
1.
Remove the connector from the switch.
2.
Check for continuity between terminals.
Seat belt condition
Continu ...
Interior
Interior A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Interior B
* These dimens ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026