Kia Forte: Variable Charge Motion Actuator (VCMA) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the VCMA connector (A).
|
| 3. |
Remove the VCMA (A) after removing 3 installation bolts.
|
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
See also:
Components
(4Door, 5Door)
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim
5. Rear wheel house trim
6. Cowl side trim
...
Front Stabilizer Bar Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Installation
•
If the oil seal on the transaxle case side is damaged
and fluid is leaking, replace ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026