Kia Forte: Variable Intake Solenoid (VIS) Valve Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the variable intake solenoid valve connector (A).
|
| 3. |
Disconnect the vacuum hoses (B) from the valve.
|
| 4. |
Remove the installation nut, and then remove the valve from the
surge tank.
|
Variable Intake Solenoid (VIS) Valve Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Variable Intake Solenoid (VIS) Valve Installation
•
Install the component with the specified torques.
•
...
See also:
Steering Column and Shaft Disassembly
Universal joint assembly
1.
Loosen the bolt (A) and then disconnect the universal joint assembly
from the steering column assembly.
Tightenin ...
Emergency while driving
In an emergency situation while the vehicle is in motion, you are able to turn
the engine off and to the ACC position by pressing the ENGINE START/STOP button
for more than 2 seconds or 3 times succ ...
Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026