Kia Forte: Blower Unit Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Unit Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
|
| 3. |
Seperate the blower unit from the heater unit after loosening
the screws.
|
| 4. |
Install in the reverse order of removal.
|
Blower Unit Components
1. Intake Seal
2. Intake Upper Case
3. Intake Actuator
4. Air Filter
5. Air Filter Cover
6. Intake Door Assembly
7. Intake Lower Case
8. NVH Pad
9. Blower Up ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage does not operate well, substitute
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Circuit Diagram
...
Component Location
1. Auto light sensor
2. Head lamps
3. Lighting switch (Auto)
4. Tail lamps
5. Body control module (BCM)
...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
Copyright © www.kifomanual.com 2014-2025