Kia Forte: Hood Assembly Replacement
| •
|
Be careful not to damage the hood and body.
|
|
| •
|
When removing and installing the hood, an assistant is
necessary.
|
| •
|
When removing the clips, use a clip remover.
|
|
|
1. |
After loosening the hood hinge (B) mounting bolts, remove the
hood assembly (A).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)
|
|
|
2. |
Install in the reverse order of removal.
|
• |
Make sure the hood locks/unlocks and opens/closes
properly.
|
|
• |
Adjust the hood alignment.
|
|
|
1.
Using a clip remover, detach the clips, and remove the hood insulator
pad (A).
...
See also:
Oil Pump Components
1. Oil pump cover
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bushing-housing
7. Reaction shaft
8. Bushing-reaction shaft
9. Sleeve
10. Bo ...
Vehicle load limit
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that c ...
Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Hood Assembly Component Location
Hood Insulator Pad Replacement