(4Door, 5Door, 2Door) |
1. |
Remove the front door module.
(Refer to Front Door - "Front Door Module")
|
2. |
Disconnect the front door latch connectors (A).
|
3. |
Remove the front door inside handle cable (A) by pulling it and
then remove the front door latch assembly (B).
|
4. |
Install in the reverse order of removal.
|
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Rear Seat Belt Retractor Component Location
(4Door, 2Door)
1. Rear seat belt retractor
(5Door)
1. Rear seat belt retractor
...
Adjustment
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~
0.08in), conform to below.
1.
Disconnect the s ...