Kia Optima Manuals

Kia Forte: In-car Sensor (DATC only) Inspection - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: In-car Sensor (DATC only) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / In-car Sensor (DATC only) Inspection

1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance between 1 and 2 terminals.

Specification
Temperature [°C(°F)]
 Resistance between terminals 1 and 2 (kΩ)
-30(-22)
 509.6
-15(5)
 216.0
0 (32)
 97.71
15(59)
 47.13
25(77)
 30.00
35(95)
 19.59
50(122)
 10.81
60(140)
 7.463

  
An in-car sensor is a negative type thermistor. The resistance will rise with lower temperature, and reduce with higher temperature.
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

See also:

Rear Seat Latch Replacement
(4Door, 2Door)    • Put on gloves to protect your hands. ...

Replacement
1. Uplift the vehicle with lift. 2. Drain the manual transaxle oil after loosening the drain plug (A). 3. ...

Rear Seat Assembly Replacement
[Rear seat cushion assembly] 1. Disconnect the rear seat cushion heater connector (A) from the trunk inner side. 2. After loosening th ...

Categories


Copyright © www.kifomanual.com 2014-2025