Kia Forte: Alternator Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Alternator Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
|
| 3. |
Disconnect the alternator connector (A) and the cable (B) from
alternator "B" terminal.
|
| 4. |
Pull out the through bolt and then remove the alternator (A).
|
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
See also:
Passenger Airbag (PAB) Module
The passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM determines if
and when to deploy the PAB.
...
Rear Seat Assembly Replacement
[Rear seat cushion assembly]
1.
Disconnect the rear seat cushion heater connector (A) from the
trunk inner side.
2.
After loosening th ...
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Clock spring
4. Horn
...
Copyright © www.kifomanual.com 2014-2024