Kia Forte: AGM Battery Inspection
| Vehicle parasitic current inspection
|
|
1. |
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
|
|
2. |
Close all doors except the engine hood, and then lock all doors.
|
(1) |
Disconnect the hood switch connector.
|
|
(3) |
Close the doors or remove the door switches.
|
|
|
3. |
Wait a few minutes until the vehicle’s electrical systems go to
sleep mode.
|
For an accurate measurement of a vehicle parasitic current,
all electrical systems should go to sleep mode. (It takes at
least one hour or at most one day.) However, an approximate
vehicle parasitic current can be measured after 10~20 minutes.
|
|
|
4. |
Connect an ammeter in series between the battery (-) terminal
and the ground cable, and then disconnect the clamp from the battery
(-) terminal slowly.
|
Be careful that the lead wires of an ammeter do not come
off from the battery (-) terminal and the ground cable to prevent
the battery from being reset. In case the battery is reset,
connect the battery cable again, and then start the engine or
turn the ignition switch ON for more than 10 sec. Repeat the
procedure from No. 1.
To prevent the battery from being reset during the inspection,
| 1) |
Connect a jump cable between the battery (-) terminal
and the ground cable.
|
| 2) |
Disconnect the ground cable from the battery (-)
terminal.
|
| 3) |
Connect an ammeter between the battery (-) terminal
and the ground cable.
|
| 4) |
After disconnecting the jump cable, read the current
value of the ammeter.
|
|
|
|
5. |
Read the current value of the ammeter.
| A. |
If the parasitic current is over the limit value, search
for abnormal circuit by removing a fuse one by one and checking
the parasitic current.
|
| B. |
Reconnect the suspected parasitic current draw circuit
fuse only and search for suspected unit by removing a component
connected with the circuit one by one until the parasitic draw
drops below limit value.
|
Limit value (after 10~20 min.)
: Below 50mA
|
|
1.
Install in the reverse order of removal.
When installing the battery, ...
1.
Make sure the ignition switch and all accessories are in the OFF
position.
2.
Disconnect the battery cables (negative first).
...
See also:
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...
Tail Gate Trim Replacement
(5Door)
[Tail gate upper trim]
•
When prying with a flat-tip screwdri ...
Changing Priority
What is Priority?
It is possible to pair up to five Bluetooth® Wireless Technology devices with
the car audio system.
The "Change Priority" feature is used to set the connection priority ...
AGM Battery Installation
AGM Battery Cleaning