Kia Forte: Inspection
| 1. |
Inspect diaphragm spring wear which is in contact with a clutch
release bearing.
|
| 2. |
Check the clutch cover and disc surface for wear or cracks.
|
| 3. |
Check the clutch disc facing for slipping or oil marks.
|
| 4. |
Measure the depth from a clutch facing surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual Transaxle")
2.
Remove the clutch cover bolts. ...
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
See also:
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
Transaxle Oil Temperature Sensor Specifications
▷ Type: Negative Thermal Coefficient(NTC) Type
Temp.[(°C)°F]
Resistance (kΩ)
(-40)-40
48.1
(-20)-4.0
15.6
(0)32.0
...
Description
The ECM (Electro Chromatic inside rear view Mirror) is for dimming the
reflecting light from a vehicle behind at night, Preventing glare from the light.
The forward facing sensor detects brig ...
Copyright © www.kifomanual.com 2014-2025