Kia Forte: Control Shaft Complete Installation - Manual Transaxle Control System - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Control Shaft Complete Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Installation

1.
Install in the reverse order of removal.
  
When installing, set control shaft lever to neutral position.

When installing, apply the sealant as shown in the illustration.

Specified sealant : MS 721-40 or MS721-38

2.
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
Control Shaft Complete Removal
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Automatic Transaxle System
...

See also:

Receiver-Drier Replacement
1. Remove the condenser, and then remove the bottom cap (B) with a L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m ( ...

Accelerator Position Sensor (APS) Circuit Diagram
(M/T) (A/T) ...

Cowl Side Trim Component Location
1. Cowl side trim ...

Copyright www.kifomanual.com 2014-2025