Kia Forte: Valve Body Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Removal
| 1. |
Disconnect the negative (-) battery cable.
|
| 2. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Remove the under cover (A).
|
| 4. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
|
| 5. |
Remove the air breather hose (A).
|
| 6. |
Remove the valve body cover (B).
|
| 7. |
Remove the plate and the detent spring (A) after removing the
bolt.
|
| 8. |
Remove the bolt (3ea) after disconnecting the solenoid valve (B)
connector and the oil temperature sensor connector (A).
|
| 9. |
Remove the valve body assembly (A).
|
Valve Body Components Location
1. Pressure Controle Valve(PCV) adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & Reverse Brake(LR/B) pressure flow hole
6. Underdrive ...
Valve Body Installation
1.
Install in the reverse order of removal.
After replacement or reinstallation procedure of ...
See also:
Back up lamp, Rear fog lamp
1. Take the lamp assembly out.
2. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
3. Remove the bulb by ...
Shift Lever Removal
1.
Remove the floor Interior console assembly.
(Refer to Body - " Floor Console")
2.
Remove the cover (A).
...
Immobilizer Control Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...
Copyright © www.kifomanual.com 2014-2025