Kia Forte: Transaxle Control Module (TCM) Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM) Replacement
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the negative (-) battery cable.
|
| 3. |
Disconnect the TCM connector (A).
|
| 4. |
Remove the TCM (A) after removing the bolt and nut.
|
Transaxle Control Module (TCM) Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harne ...
Transaxle Control Module (TCM) Installation
1.
Installation is reverse of removal.
•
...
See also:
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
Oil Pressure Switch Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1 ...
Copyright © www.kifomanual.com 2014-2025