Kia Forte: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
(Refer to Torque Converter Control Solenoid Valve - "Specifications")
Torque Converter Control Solenoid Valve (T/CON_VFS) Circuit Diagram
...

Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

See also:

Checking the brake/clutch  fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch* ...

Alternator Components
1. OAD (Overrunning Alternator Decoupler) pulley 2. Front housing 3. Front bearing 4. Stator 5. Rotor 6. Rear bearing 7. Rear housing 8. Rectifier assembly 9. Re ...

Inpection
1. Measure a resistance of NTC and Heated pad. A. NTC resistance - 10.0 kΩ ± 10% (25°C) B. H ...

Copyright © www.kifomanual.com 2014-2025