Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Circuit Diagram

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications

Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA) ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection

1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

See also:

Rear Coil Spring Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Fuel Tank Pressure Sensor (FTPS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring t ...