Kia Forte: SS-B Solenoid Valve(ON/OFF) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to SS-B Solenoid Valve - "Specifications")
|
SS-B Solenoid Valve(ON/OFF) Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
See also:
Rear Alignment Adjustment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Auto Light Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto light sensor (A) from crash pad upper side by
using screw (-) driver.
...
Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TC ...
Copyright © www.kifomanual.com 2014-2025