Kia Optima Manuals

Kia Forte: Inhibitor Switch Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inhibitor Switch Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Inspection

  
•
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Power Circuit Inspection
1.
Disconnect the Inhibitor swtich connector.
2.
Ignition KEY "ON"" & Engine "OFF".
3.
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Signal Circuit Inspection
1.
Connect the Inhibitor switch connector.
2.
Ignition KEY "ON" & Engine "OFF".
3.
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
Signal Code Table
　
 P
 P-R
 R
 R-N
 N
 N-D
 D
Signal "1"
 12V
 12V
 0
 0
 0
 0
 0
Signal "2"
 0
 12V
 12V
 12V
 0
 0
 0
Signal "3"
 0
 0
 0
 12V
 12V
 12V
 0
Signal "4"
 0
 0
 0
 0
 0
 12V
 12V

Inhibitor Switch Circuit Diagram
...

Inhibitor Switch Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner. (Refer to Engine Mechanical System - "Air clea ...

See also:

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") Remove the manual transaxle. (Refer to Manual ...

Power Door Lock Relay Inspection
Diagnosis With GDS 1. It will be able to diagnose defects of power door lock with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Categories

Copyright � www.kifomanual.com 2014-2026