Kia Forte: Shift Lever Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Shift Lever Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Removal

1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Remove the air duct.
3.
Disconnect the control cable (A).

4.
Disconnect the connector (A).
5.
Disconnect the wire mounting clips (B).
6.
Remove the bolts and then shift lever assembly (A).

Tightening torque:
8.8 ~ 13.7N.m(0.9 ~ 1.4kgf.m, 6.5 ~ 10.1lb-ft)

Shift Lever Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Lever Installation
1. Install in the reverse order of removal.    Install the cable after placi ...

See also:

Center Pillar Trim Component Location
(4Door, 5Door) 1. Center pillar lower trim 2. Center pillar upper trim (2Door) 1. Rear inner outer trim 2. Center pillar upper ...

Relay Box (Engine Compartment) Inspection
Power Relay Test (Type A)    - Do not use pliers. - ...

Troubleshooting
Symptom Suspect area Engine will not start or hard to start Vapor hose damaged or disconnected Engine hard to start Malfunction of the Purge C ...

Copyright © www.kifomanual.com 2014-2025