Kia Forte: Removal - Front Impact Sensor (FIS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) / Removal

  
Removal of the airbag must be performed according to the precautions/ procedures described previously.
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Left side - Remove the head lamp assembly.
(Refer to Body electrical - "Head Lamps")
Right side - Remove the washer reservoir.
(Refer to Body electrical - "Front washer motor")
3.
Disconnect the front impact sensor connector (A).

4.
Remove the front impact sensor after loosening the mounting nut (B).
Components
...

Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Removal
1. Engine cover. (Refer to Engine Mechanical System - "Engine cover") 2. Air cleaner assembly and air duct. (Refe ...

Fluid Service Adjustment Procedure
Oil level Check    A check of Automatic Transaxle Fluid (ATF) level is not normally required during scheduled ...

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Copyright www.kifomanual.com 2014-2026